Cutter Operator

Description:

Responsible for operation of robots, cutters and associated equipment to affect the timeliness and quality cutting of blends Into the blend boxes. This is accomplished by setting the robot discharge rate, cutter belt speed, diverter setups In the plant floor control panel to the most optimum settings for each grade. The operator should be skilled at changing the robot and cutter bls1des, vibrator pads, unchoklng dlverters, and removing knots'' from all rolls and belts. The operator should be skilled at routine servicing procedures for cutters and robots.

General responsibilities:

Perform other tasks as assigned by supervisor

Recommend safety improvements

Recommend production Improvements

Comply with all safety and management programs

Be an active participant In work team development

Keep workplace clean and orderly

Provide On-The-Job training as assigned by supervisor for other employees

Job Risks:

Pinching, compression, tripping, eyes, electricity, cuts and abrasion, and fire

Safety equipment required: Gloves, safety glasses, ear plugs, face shields, and dust mask (optional)

General requirements:

Capable of performing tasks Including but not limited to working at heights and working in confined spaces. Able to read, write and convey ideas. Must be able to lift at least 50 pounds with adequate body flexibility

Quality:

Maintain quality standards by product as assigned

Cleaning:

Specifically but not limited to- Cutters, fans, diverters, blending box tops, between blending boxes up to heads, associated aisles, walls overhead structures and ductwork.

Training:

Fully understand and demonstrate competence In tasks as described In the Job Task Analysis documents.

Specific Tasks:

Forklift Operation

Forklift Inspection and basic servicing

Scissor Lift Operation

Cutter blade change and adjustment

Vibrator Pad replacement

Elevator Cleaning

Operation of cardboard and waste balers

Cutter Operation

Bale opening procedures

Cleaning Diverters and ducts of choke-ups

General Cleaning procedures

Cutter changeover and setup procedures

Perform tasks as trained & obtain specific instructions from your supervisor for.any variances